DTC C2005-77: Right Actuator - Commanded position not reachable: Action
- Check the integrity of the right rear brake disc and brake pads and that the right electric park brake actuator is correctly installed
- Refer to the electrical circuit diagrams and check the right electric park brake actuator circuits for correct polarity and for open circuit, high resistance. Repair the circuits as required
- Perform ignition cycle. Using the electric park brake switch, release, apply and release the switch with little or no brake pressure
- If the fault persists, connect the right actuator to the left side wiring harness and the left actuator to right side wiring harness. Apply and release the park brake switch. If the fault has changed sides, install a new right electric park brake actuator. If the fault is still the right side, check the right actuator circuit for open circuit, high resistance