Replacement Module Routine Must Be Run When Replacing Any Modules (SSM76100)

Publication date: 2023-10-09
Reference number: SSM76100

REPLACEMENT MODULE ROUTINE MUST BE RUN WHEN REPLACING ANY MODULES

TECHNICAL SERVICE BULLETIN

Reference Number(s): SSM76100, Date of Issue: October 09, 2023

LAND ROVER:	Defender/L663; Discovery/L462; Discovery Sport/L550; New Range Rover/L460; New Range Rover Evoque/L551; New Range Rover Sport/L461; Range Rover Velar/L560
SERVICE CATEGORY:	Diagnostic Software Hardware

SITUATION

JLR Engineering investigations have found that, in some instances, software updates and configurations have not been completed after new headlamps, Electric Power Assisted Steering (EPAS) gears or electrical modules are installed.

Although the new parts will function without the replacement module routine being run, they will not be configured to the vehicle or at the correct software level.

ACTION

Follow the instruction(s) below.

SERVICE INFORMATION

When a replacement electrical module is installed, the replace module routine MUST be run by following the process in TOPIx Cloud.

Open 'Diagnostics' tab in TOPIx Cloud
Select the module to be updated from 'Vehicle Data' module list in LH column
Select 'Module Programming' in RH column, within the 'Applications and Troubleshooting' list
Select and run the applicable 'Replace Module' routine

(Ref 000001160)