Adaptive Speed Control Module (G2299362): Installation

Install the Adaptive Speed Control Module (ASCM) to the bracket.
- Install the ASCM module assembly to the bumper bracket.
- Install and tighten the 4 screws.
  Torque : 2 Nm
- Install the ASCM assembly to the bumper.
- Install the clip.
- Install and tighten the 3 screws.
  Torque : 2 Nm
Connect the electrical connector.
Install the front bumper.
Refer to: FRONT BUMPER .
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
NOTE:
- This step is only required if the component was removed for access.
- Choose a road with stationary objects on the roadside.
- Following vehicles too closely will obscure the stationary targets from the radar, a gap of 2 seconds is recommended.
1. Connect the Jaguar Land Rover (JLR) approved diagnostic equipment.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
2. Select 'Cruise Control Module [CCM] - Service Alignment Mode' from the diagnostic menu.
3. Make sure that all steps from the on-screen instructions are followed.
NOTE:
- This step is only required if a new component is installed.
- Choose a road with stationary objects on the roadside.
- Following vehicles too closely will obscure the stationary targets from the radar, a gap of 2 seconds is recommended.
1. Connect the JLR approved diagnostic equipment.
  General Equipment: Jaguar Land Rover approved diagnostic equipment
2. Select 'Cruise Control Module [CCM] - Replace ECU' from the diagnostic menu.
3. Make sure that all steps from the on-screen instructions are followed.