DTC B108E-46: Display - Calibration/parameter memory failure: Action

NOTE: This DTC may be set even though no fault condition is present and should be ignored unless the customer has reported a problem with the instrument panel cluster control module display failing to turn ON

Refer to the electrical circuit diagrams and check pins 1 and 17 of the 32 way instrument panel cluster control module connector for battery voltage. Repair the wiring harness as necessary. Clear the Diagnostic Trouble Code(s) and retest
Refer to the electrical circuit diagrams and check pins 9 and 25 of the 32 way instrument panel cluster control module connector are connected to ground. Repair the wiring harness as necessary. Clear the Diagnostic Trouble Code(s) and retest
Using Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest. If the fault persists, install a new instrument panel cluster control module
If a new instrument panel cluster control module is installed, perform routines - Learn VIN (0x0404) and Write Odometer Value (0x8018)