LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1995 >> SC 400 >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Disc Brakes) >> Bleeding Brake System >> Bleeding Procedures >> Traction Control System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Traction Control System

WARNING: This page is about a different car, the 1996 Lexus SC 300 and 1995 Lexus SC 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure master cylinder reservoir is full of brake fluid. Turn ignition off. Bleed TRAC control system by connecting a vinyl tube to accumulator bleeder screw. Loosen bleeder screw. Start engine and allow the TRAC pump motor to operate until all the air has been bled from accumulator side. Tighten bleeder screw to 74 INCH lbs. (8.4 N.m) and turn engine off.
  2. Connect a vinyl tube to bleeder screw of TRAC actuator. Loosen bleeder screw. Start engine and allow the TRAC pump to operate until all the air has been bled from actuator side. Tighten bleeder screw to 74 INCH lbs. (8.4 N.m) and turn engine off.
  3. Ensure there are no Diagnostic Trouble Codes (DTCs) stored. Clear codes if necessary. See TRACTION CONTROL article. Fill brake fluid reservoir with engine at idle.
scientia non olet · About LEMON Manuals