LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1996 >> SC 300 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Circuit Tests >> DTC P0125 - Insufficient Coolant Temperature For Closed Loop Fuel Control >> Diagnosis & Repair
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Diagnosis & Repair

  1. Remove instrument panel fuse cover. Connect scan tester to Data Link Connector (DLC) No. 3. See Figure. Start engine and warm to normal operating temperature. Turn scan tester on. Monitor each oxygen sensor. Snap accelerate engine 3 times. Sensors should indicate a rich signal (.45 volt or more) at least once.
  2. If a rich signal is indicated for both sensors, replace ECM and retest. If either sensor does not display a rich signal, inspect circuits between ECM and suspect sensor for open or short circuits. Repair as necessary. If circuits are okay, replace oxygen sensor and retest.
scientia non olet · About LEMON Manuals