Power Mirror Position Sensor Test
- Disconnect power mirror motor connector. Connect three 1.5-volt dry cell batteries together in series. Connect dry cell positive lead to terminal No. 9 and negative lead to terminal No. 15. See Fig 1. Connect positive lead of voltmeter to terminal No. 16 and negative lead to terminal 15.
- While watching voltmeter, apply battery voltage to terminals No. 7 and 6, reversing polarity as necessary to move mirror in both directions. As mirror moves, voltage should gradually and smoothly change from 0.0-1.8 volt to 2.8-5.0 volts. If voltage is not as specified, replace power mirror. If voltage is as specified, go to next step.
- Disconnect voltmeter and battery voltage from motor connector terminals (leave dry cell assembly connected). Connect positive lead of voltmeter to terminal No. 10 and negative lead to terminal No. 15.
- Apply battery voltage between terminals No. 7 and 8, reversing polarity as necessary to move mirror in both directions. As mirror moves, voltage should gradually and smoothly change from 0.0-1.8 volt to 2.8-5.0 volts. If voltage is not as specified, replace power mirror.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002