Camshaft Position Sensor: Service and Repair
REPLACEMENT1. REMOVE AIR CLEANER INLET NO.1
2. DRAIN ENGINE COOLANT
3. REMOVE V-BANK COVER
4. REMOVE ENGINE ROOM SIDE COVER
5. DISCONNECT RADIATOR HOSE NO.1
6. REMOVE TIMING BELT COVER SUB-ASSEMBLY NO.3 LH
7. REMOVE CAMSHAFT POSITION SENSOR
a. Remove the bolt, stud bolt and sensor.
8. INSTALL CAMSHAFT POSITION SENSOR
a. Install a new sensor with the bolt and stud bolt.
Torque: 7.5 N.m (76 kgf.cm, 66 in.lbf)
9. INSTALL TIMING BELT COVER SUB-ASSEMBLY NO.3 LH
10. CONNECT RADIATOR HOSE NO.1
11. INSTALL AIR CLEANER INLET NO.1
12. INSTALL ENGINE ROOM SIDE COVER
13. INSTALL V-BANK COVER
14. REFILL ENGINE COOLANT
15. WARM UP ENGINE
16. CHECK FOR ENGINE COOLANT LEAKS