Inspection Procedure

1. NG: CHECK FOR SHORT IN ALL THE HARNESS AND COMPO-NENTS CONNECTED TO ECU-IG1 FUSE, AND REPAIR THEM. 
2. OK: Go to Next Step. 

PREPARATION: 

Remove Power Seat Control ECU with connectors being connected.

CHECK: 

Measure voltage between terminal IG of Power Seat Control ECU connector and body ground when ignition switch is ON and OFF.

OK: 

Fig 1: Checking Voltage Between Terminal IG Of Power Seat Control ECU Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. OK: Proceed to next circuit inspection shown on problem symptom table (See  PROBLEM SYMPTOMS TABLE   ). 
2. NG: Check and repair harness or connector between Power Seat Control ECU and battery.