System Check Mode (DTC Clear/Recheck)
- Clearing individual DTC memory (when clearing the memory of DTCs detected in the past individually)
- Press the preset switch "5" for 2 seconds or more while "ECHn" is displayed in the service check mode or during the detailed information mode.
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory is cleared, only the component code (physical address) is displayed for the target component.
- To check DTCs, press the preset switch "1" and perform the service check again.
- Press the preset switch "5" for 2 seconds or more while "ECHn" is displayed in the service check mode or during the detailed information mode.
- Clearing entire DTC memory (when clearing entire memory of DTCs detected in the past)
- Start the diagnosis mode after repairing the trouble area.
- Press the preset switch "5" for 2 seconds or more ("CLR" is displayed at this time).
HINT:
- A beep sound is emitted once when the DTC memory is completely cleared.
- When the DTC memory for all components is cleared, only the component codes (physical address) are displayed.
- Press the preset switch "1" to perform the service check again, and check that no DTCs are displayed for all the component codes (physical address).
- Finishing diagnostic mode
- Press the "DISC" switch for 2 seconds or more, or turn the ignition switch OFF.