Data List/Active Test
- READ DATA LIST
HINT:
Using the hand-held tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON.
- Read the DATA LIST.
Transponder key ECU assy:
DIAGNOSTIC TABLEItem Measurement Item/Display (Range) Normal Condition Diagnostic Note KEY SW Unlock warning switch signal/ON or OFF ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder- IMMOBILIZER Immobilizer system status/SET or UNSET SET: No key is in ignition key cylinder
UNSET: Ignition switch ON- RESPONSE Transponder chip data/NG or OK NG: Data error
OK: Data OK- FRAME Transponder chip data/NG or OK NG: Data error
OK: Data OK- SERIAL NUMBER Transponder chip data/NG or OK NG: Data error
OK: Data OK- ENCRYPT CODE Transponder chip data/NG or OK NG: Data error
OK: Data OK- STATUS Transponder chip data/NG or OK NG: Data error
OK: Data OK- BCC Transponder chip signal/NG or OK NG: Incorrect data is sent
OK: Correct data is sent- SUB KEY Sub-key code signal/NOMATCH or MATCH NOMATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent- MASTER KEY Master key code signal/NOMATCH or MATCH NOMATCH: Unmatched master key code is sent
MATCH: Master key code is sent- REGIST SUB CODE Number of registered sub-keys/min: 0; max: 15; Number of registered sub-keys - REGIST MAS CODE Number of registered master keys/min: 0; max: 15; Number of registered master keys - REG CODE SPACE Memory space for key code registration/NOT FUL or FULL NOT FUL: Possible to register more key codes
FULL: Cannot register any more key codes- Theft warning ECU assy:
DIAGNOSTIC TABLEItem Measurement Item/Display (Range) Normal Condition Diagnostic Note ACC SW Ignition switch signal/ON or OFF ON: Ignition switch on ACC
OFF: Ignition switch OFF- IG SW Ignition switch signal/ON or OFF ON: Ignition switch ON
OFF: Ignition switch OFF or on ACC- - PERFORM ACTIVE TEST
HINT:
Performing the hand-held tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.