Cruise Main Indicator Light Circuit: Description
- The ECM detects a cruise control switch signal and sends it to the combination meter via CAN and BEAN. Then the CRUISE main indicator light comes on.
- The CRUISE main indicator light circuit uses CAN and BEAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system and multiplex communication system before troubleshooting this circuit.
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Check the CRUISE main indicator light by using ACTIVE TEST.
Combination meter:
ACTIVE TESTItem Test Details Diagnostic Note CRUISE INDIC CRUISE main indicator light is ON / OFF - OK : Indicator light comes on / goes off.
NG : GO TO COMBINATION METER SYSTEM
OK : GO TO NEXT STEP
- READ VALUE OF INTELLIGENT TESTER
- Connect the intelligent tester to the DLC3.
- Turn the engine switch on (IG) and turn the intelligent tester main switch ON.
- Check the DATA LIST for proper functioning of the CRUISE main indicator light.
ECM (Cruise control):
DATA LISTItem Measurement Item / Display (Range) Normal Condition Diagnostic Note CCS INDICATOR M Cruise indicator signal (Main CPU) / ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF- OK : When cruise control main switch operation is performed, the result will be same as above.
NG : REPLACE ECM
OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE