Height Control Compressor: Installation

1. Install the 3 bushings to the height control compressor assembly.
2. Install the bolt, the dryer and the new O-ring.

   Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf) 

3. Assemble the height control compressor, the dryer and the bracket as a unit to the vehicle, and tighten the 3 bolts to fix the bracket to the frame.

   Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf) 

4. Install the height control compressor assembly to the bracket with the 3 bolts.

   Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf) 

5. Install the 3 clamps.
6. Connect the connector.
7. Connect the No. 1 hose with a new clip.

1. Coat 2 new O-rings with MP grease.
2. Push the height control tube No. 2 in straight to connect it until the clip makes "click" sound.
   NOTE: Do not get scratches or foreign particles on the O-ring, O-ring seal and flare section.
3. Install the holder.

1. Install the height control filter with the new 2 bolts.

   Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf) 

2. Connect 2 new clips and 2 hoses.

1. Install the height control compressor cover with 3 new clips.

1. Install the fuel tank filler pipe protector with the 4 clips.

Torque: 112 N*m (1,140 kgf*cm, 83 ft.*lbf)