Cruise Control Main Switch: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 430 and 2006 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRUISE CONTROL MAIN SWITCH
1. Install the switch with the 2 screws.
  Torque: 1.7 to 3.0 N*m (17 to 31 kgf*cm, 15 to 27 in.*lbf)
2. Connect the connector.
INSTALL STEERING WHEEL ASSEMBLY
For 3GR-FSE (see INSTALLATION )

For 3UZ-FE (see INSTALLATION )

Fig 1: Identifying Steering Wheel Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING WHEEL PAD (See INSTALLATION )
INSTALL STEERING WHEEL NO. 3 COVER LOWER
INSTALL STEERING WHEEL NO. 2 COVER LOWER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

Perform initialization (see INITIALIZATION ).
CHECK SRS WARNING LIGHT
Check the SRS warning light (see DIAGNOSIS SYSTEM ).