Dynamic Radar Cruise Control System: Installation
WARNING: This page is about a different car, the 2006 Lexus GS 430 and 2006 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
- Install the millimeter wave radar sensor with the 3 bolts.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
- Connect the connector.
- Install the millimeter wave radar sensor with the 3 bolts.
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (See DIAGNOSTIC TROUBLE CODE CHART )
- INSTALL FRONT BUMPER COVER (See INSTALLATION )
- INSTALL FRONT FENDER LINER LH (See INSTALLATION )
- INSTALL FRONT FENDER LINER RH (See INSTALLATION )
- INSTALL ENGINE UNDER COVER (See INSTALLATION )
- INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
- PERFORM INITIALIZATION
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).