Ignition Coil: Installation

INSTALL IGNITION COIL ASSEMBLY
1. Install the 6 ignition coils with the 6 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
2. Connect the 6 ignition coil connectors.
  
  Fig 1: Locating Ignition Coils With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Attach the 3 wire harness clamps and connect the noise filter connector.
  
  Fig 2: Locating Wire Harness Clamps And Filter Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See INSTALLATION )
INSTALL NO. 2 VENTILATION HOSE (See INSTALLATION )
INSTALL V-BANK COVER (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.