Inspection Procedure
NOTE:
When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (see
INSTALLATION ).
- ADJUST MILLIMETER WAVE RADAR SENSOR
Refer to ADJUSTMENT .
HINT:
It is necessary to make the ECM recognize specification information (whether the vehicle is equipped with the dynamic radar or not). When this procedure has not been carried out, this DTC may be output.
- Clear the DTC and then recheck for DTCs.
OK:
DTC is not output
NG: REPLACE MILLIMETER WAVE RADAR SENSOR
OK: SYSTEM OK
- Clear the DTC and then recheck for DTCs.