Terminals Of Ecu

CHECK TELEVISION CAMERA ASSEMBLY

Fig 1: Identifying Television Camera Assembly Connector Terminal Y8

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage and resistance between each terminal of the wire harness side connector.

CONNECTOR TERMINAL REFERENCE CHART

Symbols (Terminal No.)	Wiring Color	Terminal Description	Condition	Specified Condition
CGND (Y8-3) - Body ground	W - Body ground	Ground	Always	Below 1 Ω
CB+ (Y8-4) - CGND (Y8-3)	B - W	Power source	Engine switch on (IG), shift lever R position	Approx. 6 V

If the result is not as specified, there may be a malfunction on the wire harness side.

Measure the voltage and frequency between each terminal of the connector.

CONNECTOR TERMINAL REFERENCE CHART

Symbols (Terminal No.)	Wiring Color	Terminal Description	Condition	Specified Condition
CV+ (Y8-2) - CV- (Y8-1)	R - Shielded	Display signal	Engine switch on (IG), shift lever R position	See waveform

If the result is not as specified, the camera may have a malfunction.

Using an oscilloscope, check the waveform.

Waveform

WAVEFORM REFERENCE CHART

Item	Content
Symbols (Terminal No.)	CV+ (Y8-2) - CV- (Y8-1)
Tool Setting	0.2 V/DIV., 0.2 μsec/DIV.
Condition	Engine switch on (IG), shift lever in R position

Fig 2: Oscilloscope Waveform Graph