LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> IS 250 AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock >> Entry Lock And Unlock Switch >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Entry Lock And Unlock Switch: Installation

  1. INSTALL FRONT DOOR OUTSIDE HANDLE SUB-ASSEMBLY 
    1. Insert the front end of the front door outside handle sub-assembly in to the front door out side handle frame.
      2. Fig 1: Identifying Front Door Outside Handle Sub-Assembly
      G05252823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next slide the front door outside handle assembly to the front of the vehicle to install it.
    3. Using a "torx" socket wrench (T30), install the front door outside handle sub-assembly with the screw.
    4. Connect the connector.
  2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (See  REASSEMBLY  ) 
  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY (See  REASSEMBLY  ) 
  4. INSTALL FRONT DOOR SERVICE HOLE COVER (See  REASSEMBLY  ) 
    Fig 2: Identifying Screw
    G05320750Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL FRONT DOOR TRIM COVER (See  REASSEMBLY  ) 
  6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See  REASSEMBLY  ) 
  7. INSTALL COURTESY LIGHT ASSEMBLY (See  REASSEMBLY  ) 
  8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (See  REASSEMBLY  ) 
  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG (See  REASSEMBLY  ) 
scientia non olet · About LEMON Manuals