LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Can Communication >> Can Communication System >> DTC U0123 Lost Communication with Yaw Rate Sensor Module >> Inspection Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection Procedure

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
      NOTE:
      • After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
      • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  2. CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE) 
    Fig 1: Identifying Terminals Of L71 Yaw Rate Sensor Connector
    G04953397Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the L71 yaw rate sensor connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      L71-3 (CA1H) - L71-2 (CA1L) Engine switch off 54 to 69 Ω

    NG: REPAIR OR REPLACE YAW RATE SENSOR BRANCH WIRE OR CONNECTOR (CA1H, CA1L) 

    OK: GO TO NEXT STEP 

  3. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR - BATTERY AND BODY GROUND) 
    1. Connect the cable to the negative (-) battery terminal.
      NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
    2. Disconnect the L71 yaw rate sensor connector.
      Fig 2: Identifying Terminals Of L71 Yaw Rate Sensor Connector
      G04953398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      L71-1 (GND) - Body ground Always Below 1 Ω
    4. Measure the voltage according to the value(s) in table below.

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      L7-M (IG) - Body ground Engine switch on (IG) 11 to 14 V

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: REPLACE YAW RATE SENSOR  (See REMOVAL )

scientia non olet · About LEMON Manuals