Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)

Disconnect the E47 connector of the ECM.

Fig 1: Identifying E47 Connector Terminal And ECM Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Specified Condition
TC (E1-13) - TC (E47-23)	Below 1 Ω

Reconnect the ECM connector.

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TC of DLC3 - ECM)

OK: Go to Next Step

CHECK HARNESS AND CONNECTOR (TC of DLC3 - BODY GROUND)

Measure the resistance.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Specified Condition
TC (E1-13) - Body ground	10 kΩ or higher

Fig 2: Identifying DLC3 Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TC CIRCUIT)

OK: Go to Next Step

CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

Measure the resistance.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Specified Condition
CG (E1-4) - Body ground	Below 1 Ω

Fig 3: Identifying CG Of DLC3 Connector Terminal

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (CG of DLC3 - BODY GROUND)

OK: REPLACE ECM