Multi-Display Controller: Installation
WARNING: This page is about a different car, the 2006 Lexus RX 400h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL MULTI-DISPLAY CONTROLLER
- Install the television display bracket B with the 2 screws.
- Install the television display bracket A with the 2 screws.
- Install the multi-display controller with the 3 nuts.
- Connect the 6 connectors.
- INSTALL TELEVISION CAMERA ECU (w/ Rear View Monitor)
- INSTALL ROOF SIDE GARNISH ASSEMBLY INNER RH (See INSTALLATION )
- INSTALL NO.1 TONNEAU COVER HOLDER CAP
- INSTALL NO.2 ROOM LIGHT ASSEMBLY (See INSTALLATION )
- INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (See INSTALLATION )
- INSTALL ROPE HOOK (See INSTALLATION )
- INSTALL REAR SEAT SIDE COVER RH (See INSTALLATION )
- INSTALL REAR NO.1 SEAT BELT ASSEMBLY OUTER RH (See INSTALLATION )
- INSTALL DECK SIDE TRIM COVER RH (See INSTALLATION )
- INSTALL REAR FLOOR FINISH SIDE PLATE RH (See INSTALLATION )
- INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
- INSTALL DECK SIDE TRIM BOX LH (See INSTALLATION )
- INSTALL DECK SIDE TRIM BOX RH
- INSTALL BACK DOOR WEATHERSTRIP
- INSTALL DECK NO.3 BOARD SUB-ASSEMBLY (See INSTALLATION )
- INSTALL DECK NO.2 BOARD SUB-ASSEMBLY (See INSTALLATION )
- INSTALL DECK FLOOR BOX REAR (See INSTALLATION )
- INSTALL DECK FLOOR BOX FRONT (See INSTALLATION )
- INSTALL JACK CARRIER ASSEMBLY
- INSTALL JACK ASSEMBLY
- INSTALL JACK CARRIER SUPPORT
- INSTALL TONNEAU COVER ASSEMBLY
- INSTALL DECK BOARD SUB-ASSEMBLY (See INSTALLATION )
- INSTALL REAR DOOR SCUFF PLATE RH (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION NOTE: Some systems need initialization when disconnecting the cable from negative battery terminal. (See INITIALIZATION )