Data List / Active Test

HINT:

Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch on.
3. Read the DATA LIST according to the display on the tester.

   CCS: 

   DATA LIST
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   VEHICLE SPD	Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)	Actual vehicle speed	-
   MEMORY SPD	Cruise control memorized speed / min.: 1 km/h (0.6 mph), max.: 255 km/h (158 mph)	Actual stored vehicle speed	-
   THROTTLE	Required throttle opening angle / min.: 0°, max.: 125°	Actual required throttle opening	-
   CRUISE CONTROL	Cruise control system active condition / ON or OFF	ON: Cruise control activated OFF: Cruise control inactivated	-
   MAIN SW (MAIN)	Main switch signal (Main CPU) / ON or OFF	ON: Main switch ON (Pushed on) OFF: Main switch OFF (Pushed off)	"3"
   CCS READY M	Cruise control system standby condition (Main CPU) / ON or OFF	Each time main switch is pushed, ON is displayed and then OFF is displayed	"1"
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CCS READY" ON OFF: "CCS READY" OFF	"2"
   CANCEL SW	CANCEL switch signal / ON or OFF	ON: CANCEL switch ON OFF: CANCEL switch OFF	-
   SET/COAST SW	-/SET switch signal / ON or OFF	ON: -/SET switch ON OFF: -/SET switch OFF	-
   RES/ACC SW	+/RES switch signal / ON or OFF	ON: +/RES switch ON OFF: +/RES switch OFF	-
   STP LIGHT SW M	Stop light switch signal (Main CPU) / ON or OFF	ON: Brake pedal depressed OFF: Brake pedal released	-
   SHIFT D POS	PNP switch signal (D position) / ON or OFF	ON: Shift lever on D OFF: Shift lever not on D	-
   VEHICLE SPD CHG	Vehicle speed change / ON or OFF	ON: Change OFF: Not change	-
   HINT: "3" is OK but "1" is NG --> Hybrid vehicle control ECU failure. "1" is OK but "2" is NG --> DTC output or hybrid vehicle control ECU failure. "3" is but cruise indicator not turn on --> CRUISE MAIN indicator or wire harness or hybrid vehicle control ECU failure.