LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> ES 350 >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel >> Fuel Pressure Pulsation Damper >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Fuel Pressure Pulsation Damper: Installation

  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Apply a light coat of spindle oil or gasoline to a new O-ring and install it to the fuel pressure pulsation damper.
    2. Install the fuel pressure pulsation damper to the fuel delivery pipe.
    3. Install the clip.
      Fig 1: Identifying Pulsation Damper, O-Ring & Clip
      G04975030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY (See  INSTALLATION   ) 
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION ).
  4. ADD ENGINE COOLANT  (See ON-VEHICLE INSPECTION ).
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
  6. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  7. INSPECT FOR FUEL LEAK (See  ON-VEHICLE INSPECTION   ) 
  8. INSTALL V-BANK COVER SUB-ASSEMBLY  (See REASSEMBLY )
  9. INSTALL FRONT SUSPENSION CENTER UPPER BRACE 
  10. INSTALL ENGINE ROOM SIDE COVER RH  (See REASSEMBLY )
  11. INSTALL ENGINE ROOM SIDE COVER LH  (See REASSEMBLY )
  12. INSTALL COOL AIR INTAKE DUCT SEAL  (See REASSEMBLY )
scientia non olet · About LEMON Manuals