Console Box Light: Inspection

WARNING: This page is about a different car, the 2007 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY

Disconnect the F1 console box illumination light assembly connector.

Measure the voltage according to the value(s) in the table below.

Standard voltage

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Condition	Specified Condition
F1-2 - F1-1	Light control switch in TAIL	10 to 14 V
J46-2 - J46-1	Light control switch OFF	Below 1 V

Fig 1: Identifying F1 Console Box Illumination Light Assembly Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, there is a malfunction on the wire harness side.

Apply battery voltage to the console box illumination light assembly connector.

Check that the console box illumination light comes on.

MEASUREMENT CONDITION

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1	Console box illumination light comes on

If the result is not as specified, replace the console box illumination light assembly.

Fig 2: Identifying F1 Console Box Illumination Light Assembly Connector Terminals (Components Side)