Data List / Active Test

HINT:

Using the Techstream DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the Techstream (with CAN VIM) to the DLC3.
2. Turn the power switch ON (IG).
3. Read the DATA LIST according to the display on the tester.

   Hybrid vehicle control ECU 

   NORMAL CONDITION CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS Vehicle Spd	Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)	Actual vehicle speed	-
   CCS Mem Vehicle Spd	Cruise control memorized speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)	Actual stored vehicle speed	-
   Cruise Control	Cruise control system active condition / ON or OFF	ON: Cruise control activated OFF: Cruise control inactivated	-
   Main SW M-CPU	Main switch signal (Main CPU) / ON or OFF	ON: Main switch ON (Pushed on) OFF: Main switch OFF (Pushed off)	-
   CCS Ready M-CPU	Cruise control system standby condition (Main CPU) / ON or OFF	Each time main switch is pushed, ON is displayed and then OFF is displayed	-
   CCS Indicator M-CPU	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CCS READY" ON OFF: "CCS READY" OFF	-
   Cancel Switch	CANCEL switch signal / ON or OFF	ON: CANCEL switch ON OFF: CANCEL switch OFF	-
   SET/COAST Switch	SET / COAST switch signal / ON or OFF	ON: SET / COAST switch ON OFF: SET / COAST switch OFF	-
   RES/ACC Switch	RES / ACC switch signal / ON or OFF	ON: RES / ACC switch ON OFF: RES / ACC switch OFF	-
   Stp Light SW M-CPU	Stop light switch signal (Main CPU) /ON or OFF	ON: Brake pedal depressed OFF: Brake pedal released	-
   Cruise Request Torque	Cruise request torque / min.: -1024 N*m (-10442 kgf*cm, -755 ft.*lbf), max.: 1016 N*m (10360 kgf*cm, 749 ft.*lbf)	Actual required torque	-
   # Codes	Number of DTC recorded / 0 to 255	min.: 0 min.: 4	-

HINT:

Performing the Techstream ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

1. Connect the Techstream (with CAN VIM) to the DLC3.
2. Turn the power switch ON (IG).
3. Perform the ACTIVE TEST according to the display on the tester.

   Combination meter 

   CONTROL RANGE REFERENCE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp Cruise	CRUISE main indicator light	ON/OFF	-