LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel (4GR-FSE) >> Injector Driver >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Injector Driver: Installation

  1. INSTALL INJECTOR DRIVER 
    1. Install the injector driver with the bolt and 2 nuts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • Be careful not to drop or strike the injector driver.
      • The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
        Fig 1: Locating Injector Driver Bolt And Nuts
        G05826375Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 4 connectors to the injector driver.
      3. Fig 2: Locating Injector Driver Connectors
      G05826577Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 ENGINE COVER  (See INSTALLATION )
  3. INSTALL NO. 1 INLET AIR CLEANER  (See INSTALLATION )
  4. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
scientia non olet · About LEMON Manuals