Entry Lock And Unlock Switch: Installation

INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY
1. Insert the front end of the front door outside handle assembly into the front door out side handle frame
2. Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next, slide the front door outside handle assembly towards the front of the vehicle to install it.
  
  Fig 1: Installing Front Door Outside Handle Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a "TORX" socket wrench (T30), install the front door outside handle assembly with the screw
  Torque: 4.0 N*m (41 kgf*cm, 35 in.*lbf)
4. Connect the connector
  
  Fig 2: Locating Connector Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side) (See REASSEMBLY )
INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Driver Side) (See REASSEMBLY )
INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Front Passenger Side) (See REASSEMBLY )
INSTALL FRONT DOOR SERVICE HOLE COVER (See REASSEMBLY )
INSTALL FRONT DOOR TRIM COVER (See REASSEMBLY )
INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP (See REASSEMBLY )
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL COURTESY LIGHT ASSEMBLY (See REASSEMBLY )
INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) (See REASSEMBLY )
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) (See REASSEMBLY )
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INITIALIZE POWER WINDOW CONTROL SYSTEM
(See INITIALIZATION )