Inspection Procedure

PERFORM ACTIVE TEST BY TECHSTREAM (CRUISE MAIN INDICATOR LIGHT)

Select the Active Test, use the Techstream to generate a control command, and then check that the CRUISE main indicator light illuminates.
Combination Meter

ACTIVE LIST TABLE

Item	Test Part	-	Diagnostic Note
Indic. Lamp Cruise	CRUISE main indicator light	ON/OFF	-

OK: CRUISE main indicator light turns on/turns off.

NG: GO TO METER/GAUGE SYSTEM (See PROBLEM SYMPTOMS TABLE )

OK: Go to Next Step

READ VALUE USING TECHSTREAM (CRUISE MAIN INDICATOR LIGHT)

Check the Data List for proper functioning of the CRUISE main indicator light.
Engine

DATA LIST TABLE

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
CCS Indicator M-CPU	Cruise indicator signal (Main CPU) /ON or OFF	ON: CRUISE main indicator light is ON OFF: CRUISE main indicator light is OFF	-

OK: When cruise control main switch operation is performed, the result will be the same as above.

NG: REPLACE ECM (See REMOVAL )

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )