Operation Check
- FRONT ACTIVE STABILIZER CONTROL ACTUATOR FUNCTION INSPECTION
- Turn the power switch OFF.
- Connect the Intelligent tester or Techstream to the DLC3
- Turn the power switch ON (READY) and the tester ON
- Follow the tester screen's display and perform the front active stabilizer Active Test.
HINT:
If the Active Test cannot be performed, check for DTCs (see DTC CHECK / CLEAR ) If test mode DTC C194F and/or C1950 are output, refer to the appropriate flowchart (see DTC C194F OPERATION OF STATIC TEST MODE IS INCOMPLETE (TEST MODE DTC); DTC C1950 FRONT STABILIZER TARGET ANGLE NOT ATTAINED (TEST MODE DTC); DTC C1951 REAR STABILIZER TARGET ANGLE NOT ATTAINED (TEST MODE DTC) ).
- During the Active Test, check that the front active stabilizer operates.NOTE: During the Active Test, do not drive the vehicle.
- Intelligent tester
F STABILIZER
TESTER DISPLAY CHARTTester Display Test Part Control Range Diagnostic Note STABILIZER CHK Forced operation of front active stabilizer control actuator When turned ON, 1 to 6 below are performed in 1 sec intervals - Vehicle front tilts to left side
- Above position is maintained
- Vehicle returns to original position
- Vehicle front tilts to right side
- Above position is maintained
- Vehicle returns to original position
If operation is prohibited through fail-safe control, Active Test cannot be performed - Techstream
Front Stabilizer
TESTER DISPLAY CHARTTester Display Test Part Control Range Diagnostic Note Stabilizer Check Forced operation of front active stabilizer control actuator When turned ON, 1 to 6 below are performed in 1 sec intervals - Vehicle front tilts to left side
- Above position is maintained
- Vehicle returns to original position
- Vehicle front tilts to right side
- Above position is maintained
- Vehicle returns to original position
If operation is prohibited through fail-safe control, Active Test cannot be performed OK: Front active stabilizer operates
- Intelligent tester
- REAR ACTIVE STABILIZER CONTROL ACTUATOR FUNCTION INSPECTION
- Turn the power switch OFF
- Connect the Intelligent tester or Techstream to the DLC3
- Turn the power switch ON (READY) and the tester ON.
- Follow the tester screen's display and perform the rear active stabilizer Active Test.
HINT:
If the Active Test cannot be performed, check for DTCs (see DTC CHECK / CLEAR ). If test mode DTC C194F and/or C1951 are output, refer to the appropriate flowchart (see DTC C194F OPERATION OF STATIC TEST MODE IS INCOMPLETE (TEST MODE DTC); DTC C1950 FRONT STABILIZER TARGET ANGLE NOT ATTAINED (TEST MODE DTC); DTC C1951 REAR STABILIZER TARGET ANGLE NOT ATTAINED (TEST MODE DTC) ).
- During the Active Test, check that the rear active stabilizer operates.NOTE: During the Active Test, do not drive the vehicle.
- Intelligent tester
R STABILIZER
TESTER DISPLAY CHARTTester Display Test Part Control Range Diagnostic Note STABILIZER CHK Forced operation of rear active stabilizer control actuator When turned ON, 1 to 6 below are performed in 1 sec intervals - Vehicle rear tilts to left side
- Above position is maintained
- Vehicle returns to original position
- Vehicle rear tilts to right side
- Above position is maintained
- Vehicle returns to original position
If operation is prohibited through fail-safe control, Active Test cannot be performed - Techstream
Rear Stabilizer
TESTER DISPLAY CHARTTester Display Test Part Control Range Diagnostic Note Stabilizer Check Forced operation of rear active stabilizer control actuator When turned ON, 1 to 6 below are performed in 1 sec intervals - Vehicle rear tilts to left side
- Above position is maintained
- Vehicle returns to original position
- Vehicle rear tilts to right side
- Above position is maintained
- Vehicle returns to original position
If operation is prohibited through fail-safe control, Active Test cannot be performed OK: Rear active stabilizer operates
- Intelligent tester