Toe Control Link: Inspection

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TOE CONTROL LINK SUB-ASSEMBLY LH
1. As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.
2. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.
  Standard turning torque:
  
  1.0 to 3.4 N*m (10 to 35 kgf*cm, 9 to 30 in.*lbf)
  
  Fig 1: Checking Turning Torque
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002