Toe Control Link: Removal

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

REMOVE WHEEL HUB ORNAMENT SUB-ASSEMBLY
1. Remove the 10 bolts and ornament.
REMOVE REAR WHEEL
1. Remove the 5 nuts and wheel.
REMOVE TOE CONTROL LINK SUB-ASSEMBLY LH
1. Remove the bolt and disconnect the rear speed sensor wire from the toe control link.
2. Remove the nut.
3. Using SST, disconnect the toe control link from the axle carrier.
  SST 09610-20012
  
  NOTE: Be careful not to damage the dust cover.
  
  Fig 1: Disconnecting Toe Control Link From Axle Carrier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Place matchmarks on the adjusting cam and suspension member.
5. Remove the nut, camber adjusting cam No. 2, camber adjusting cam No. 1 and toe control link.
  
  Fig 2: Placing Matchmarks On Adjusting Cam And Suspension Member
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002