Terminals Of Ecu

CHECK TELEVISION CAMERA ASSEMBLY

Fig 1: Identifying S35 Television Camera Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage and resistance according to the value (s) in the table below.

VOLTAGE AND RESISTANCE SPECIFIED CONDITION

Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
S35-3 (CGND) - Body ground	R - Body ground	Ground	Always	Below 1 Ω
S35-4 (CB+) - S35-3 (CGND)	B-R	Power source	Engine switch on (IG), shift lever R position	5.8 to 6.5 V

If the result is not as specified, there may be a malfunction on the wire harness side.

Measure the waveform according to the value (s) in the table below.

WAVEFORM MEASUREMENT CONDITION

Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
S35-2 (CV+) - S35-1 (CV-)	W - Shielded	Display signal	Engine switch on (IG), shift lever R position	See e waveform 1

If the result is not as specified, the camera may have a malfunction.

Using an oscilloscope, check waveform 1. Waveform 1 (Reference)

WAVEFORM REFERENCE CHART

Item	Content
Terminal No. (Symbols)	S35-2 (CV+) - S35-1 (CV-)
Tool Setting	0.2 V/DIV., 0.2 μs/DIV.
Condition	Engine switch on (IG), Shift lever R position

Fig 2: Identifying Oscilloscope Waveform