Toe Control Link: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH 
   1. Insert the toe adjust cam from the rear of the vehicle and connect the toe control link. Then temporarily install the No. 2 suspension toe adjust plate with the nut.
      NOTE: Align the matchmarks of the No. 2 suspension toe adjust plate and suspension member.
      Fig 1: Aligning Matchmarks Of No. 2 Suspension Toe Adjust Plate And Suspension Member

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Temporarily install the toe control arm with the new nut to the axle carrier.
2. TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH 
   1. Tighten the 2 nuts.

      Torque: 60 N*m (612 kgf*cm, 44 ft.*lbf) for suspension member side 

      118 N*m (1203 kgf*cm, 87 ft.*lbf) for axle carrier side 

   Fig 2: Locating Toe Control Arm With Nut
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL REAR SPEED SENSOR LH  (See INSTALLATION )
4. INSTALL LOAD SENSING VALVE SENSOR BRACKET  (See INSTALLATION )
5. SABILIZE SUSPENSION 
   1. Stabilize the suspension (w/o Air Suspension) (see INSTALLATION  ).
   2. Stabilize the suspension (w/ Air Suspension) (see INSTALLATION  ).
6. INSTALL REAR WHEEL 

   Torque: 140 N*m (1428 kgf*cm, 104 ft.*lbf) 

7. CHECK SUSPENSION CONTROL SYSTEM (w/ Air Suspension) 
   1. Check the suspension control system (see OPERATION CHECK ).
8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT 
   1. Inspect and adjust the rear wheel alignment (see ADJUSTMENT  ).
9. CHECK SPEED SENSOR SIGNAL 
   1. Check the speed sensor signal (see TEST MODE PROCEDURE ).
10. ADJUST HEADLIGHT ASSEMBLY 
    1. Adjust the headlight (see ADJUSTMENT ).