Inspection Procedure

CHECK BLUETOOTH SETTING
1. Check if the Bluetooth settings are correct.
  OK:
  
  Bluetooth settings are correct.
  
  NG: SET SETTINGS CORRECTLY
  
  OK: Go to Next Step
CHECK CELLULAR PHONE
1. Check if the cellular phone is Bluetooth compatible.
  HINT:
  
  Some versions of Bluetooth compatible cellular phones may not function.
  
  OK:
  
  Phone is Bluetooth compatible.
  
  NG: END (ONLY A BLUETOOTH COMPATIBLE CELLULAR PHONE CAN BE USED)
  
  OK: Go to Next Step
CHECK SETTING
1. Check if the cellular phone functions.
  HINT:
  
  The cellular phone is unable to call under any of the following conditions.
  - The cellular phone is locked.
  - The directory is being transferred.
  - The line is crossed.
  - Transmission is regulated.
  - The power is OFF.
  - The cellular phone is not connected to Bluetooth ("Bluetooth mark" is displayed while connected).
    OK:
    
    Above conditions do not exist.
    
    NG: SET CORRECTLY
    
    OK: Go to Next Step
CHECK CELLULAR PHONE
1. Check if the cellular phone can make calls.
  HINT:
  
  When the battery is low, calls cannot be made or received.
  
  OK:
  
  Cellular phone can make calls.
  
  NG: REPLACE CELLULAR PHONE
  
  OK: Go to Next Step
CHECK RECEPTION
1. Set the cellular phone so that it can receive calls.
2. Place the cellular phone close to the multi-display.
3. Check if the cellular phone has reception according to the multi-display.
  OK:
  
  Cellular phone has reception.
  
  NG: REPLACE MULTI-DISPLAY (See REMOVAL )
  
  OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )