Console Box Light: Inspection

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CONSOLE BOX LIGHT

Inspect the console box light RH.

Apply battery voltage to the terminals of the connector, and check the LED illumination condition.

MEASUREMENT CONDITION SPECIFIED CONDITION REFERENCE CHART

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 10 (RRMP) Battery positive (-) → Terminal 3 (RGND)	Light illuminates

Fig 1: Identifying Console Box Light Connector Terminals - Console Box Light RH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Inspect the console box light LH.

Apply battery voltage to the terminals of the connector, and check the LED illumination condition

TESTER CONNECTION SPECIFIED CONDITION REFERENCE CHART

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 2 (RLMP) Battery positive (-) → Terminal 3 (RGND)	Light illuminates

Fig 2: Identifying Console Box Light Connector Terminals - Console Box Light LH

Measure the resistance according to the value (s) in the table below.

Standard resistance

MEASUREMENT CONDITION SPECIFIED CONDITION REFERENCE CHART

Tester Connection	Switch Condition	Specified Condition
5 (RRSW) - 3 (RGND)	Switch on both sides OFF	10 kΩ or higher
4 (RLSW) - 3 (RGND)	Switch on both sides OFF	10 kΩ or higher
5 (RRSW) - 3 (RGND)	Rear right side switch ON	Below 1 Ω
4 (RLSW) - 3 (RGND)	Rear left side switch ON	Below 1 Ω

If the result is not as specified, there may be a malfunction on the console box light.

Fig 3: Identifying Console Box Light Connector Terminals