Fuel Pressure Sensor: Installation: Installation

INSTALL FUEL PRESSURE SENSOR
1. Install a new gasket to the fuel pressure sensor.
2. Using SST, install the fuel pressure sensor to the No. 1 delivery pipe.
  
  Fig 1: View Of Installing Fuel Pressure Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09922-10010
  without SST
  
  Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
  
  with SST
  
  Torque: 32 N*m (324 kgf*cm, 23 ft.*lbf)
  
  HINT:
  - The torque for use with SST is the torque when SST is used at the position shown in the illustration.
  - The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.). Refer to PRECAUTION .
3. Connect the connector with the clamp.
  
  Fig 2: Location of Connector With Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY See step 9
CONNECT WATER HOSE JOINT See step 11
INSTALL INTAKE MANIFOLD
HINT:

Refer to INSTALLATION .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT FOR FUEL LEAK . Refer to ON-VEHICLE INSPECTION - Step 1