Cruise Control Main Switch: Removal: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH . Refer to REMOVAL - Step 1

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

WARNING: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTE:

w/ Navigation System (for HDD):

After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

Condition	Waiting Time
Vehicle enrolled in safety connect system	6 minutes
Vehicle not enrolled in safety connect system	1 minute

When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

REMOVE SWITCH AND VOLUME CASE . Refer to REMOVAL - Step 2
REMOVE NO. 2 STEERING WHEEL COVER LOWER . Refer to REMOVAL - Step 3
REMOVE STEERING PAD . Refer to REMOVAL - Step 4
REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY
1. Disconnect the connector and clamp.
  
  Fig 1: Identifying Connector & Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws.
  
  Fig 2: Identifying Cruise Control Main Switch Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the switch.
  
  Fig 3: Identifying Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002