Power Management Control Ecu: Installation: Installation

WARNING: This page is about a different car, the 2012 Lexus CT 200h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL POWER MANAGEMENT CONTROL ECU
1. Engage the 2 claws to install the power management control ECU as shown in the illustration.
  
  Fig 1: Identifying Power Management Control And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ECU INTEGRATION BOX RH
1. Install the ECU integration box RH with the 2 nuts and bolt.
2. Engage the clamp to connect the wire harness.
3. Connect each connector.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY . Refer to INSTALLATION - Step 22
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 26
INSTALL INSTRUMENT SIDE PANEL RH . Refer to INSTALLATION - Step 27
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:

Use the same procedure as for the LH side. Refer to INSTALLATION - Step 43 .
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side. Refer to INSTALLATION - Step 44 .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE . Refer to INSTALLATION - Step 70
INSTALL DECK FLOOR BOX RH . Refer to INSTALLATION - Step 71
INSTALL REAR NO. 3 FLOOR BOARD . Refer to INSTALLATION - Step 72
INSTALL REAR DECK FLOOR BOX . Refer to INSTALLATION - Step 73
INSTALL REAR NO. 2 FLOOR BOARD . Refer to INSTALLATION - Step 74
PERFORM DIAGNOSTIC SYSTEM CHECK
1. Perform diagnostic system check. Refer to DTC CHECK / CLEAR .
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM