Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier: Procedure
- CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
- Disconnect the G9 radio receiver assembly connector.
- Disconnect the O33 stereo component amplifier assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G9-11 (IVO+) - O33-15 (II1+) Always Below 1 Ω G9-12 (IVO-) - O33-14 (II1-) Always Below 1 Ω G9-11 (IVO+) - Body ground Always 10 kΩ or higher G9-12 (IVO-) - Body ground Always 10 kΩ or higher G9-13 (SLD1) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [03/2012 - 07/2012]