LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2015 >> GX 460 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Access System (Keyless Entry) (Diagnostic Codes & Symptom Tests) >> SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function) >> Symptom Tests >> Room Oscillator does not Recognize Key [08/2013 - ] >> Inspection Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection Procedure

NOTE:
  • The smart access system with push-button start (for Entry Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - ] . Troubleshoot the smart access system with push-button start (for Entry Function) after confirming that the communication systems are functioning properly.
  • When using the Techstream with the engine switch off to troubleshoot:

    Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

  • Before replacing the certification ECU, refer to the smart access system with push-button start (for Entry Function). Refer to PRECAUTION [08/2013 - ] .
  • After repair, confirm that no DTCs are output by performing the "DTC Output Confirmation Operation".
  • Indoor electrical key antenna assemblies have an antenna coil between each two CLG terminals.
scientia non olet · About LEMON Manuals