Installation [05/2023 - ]: Procedure

INSTALL ACCELERATION SENSOR
1. for LH side:
  1. Install the acceleration sensor with the 2 nuts.
    Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf)
    NOTE:
    Avoid any impact to the acceleration sensor.
    
    Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
  2. Connect the connector.
  3. Return the floor carpet to its original position.
2. for RH side:
  1. Install the acceleration sensor with the 2 nuts.
    Torque: 5.5 N.m (56 kgf/cm, 49 in.lbf)
    NOTE:
    Avoid any impact to the acceleration sensor.
    
    Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
  2. Connect the connector.
  3. Return the floor carpet to its original position.
INSTALL FRONT DOOR OPENING TRIM COVER LH
Refer to PROCEDURE - Step 38
INSTALL FRONT DOOR OPENING TRIM COVER RH
Refer to PROCEDURE - Step 39
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 40
INSTALL FRONT DOOR SCUFF PLATE RH
Refer to PROCEDURE - Step 41
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 2

NOTE:
After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

Refer to TEST MODE PROCEDURE [01/2017 - ]
INSTALL NO. 2 DECK BOARD
Refer to PROCEDURE - Step 13
INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [05/2023 - ]