Power Window Single Switch
WARNING: This page is about a different car, the 2002 Lincoln Navigator and 2002 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
Remove suspect window switch. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION. Check continuity between appropriate terminals with switch in appropriate position. See SINGLE SWITCH TESTING table. See Fig 1. Continuity should exist at all times between terminals No. 1 and 5 (switch illumination circuit). If continuity is not as specified, replace switch.
SINGLE SWITCH TESTING
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| Right Front & Left Rear | ||
| Neutral | 2 & 6; 3 & 7 | |
| Down | 4 & 6 | |
| Up | 3 & 4 | |
| Right Rear | ||
| Neutral | 2 & 3; 6 & 7 | |
| Down | 3 & 4 | |
| Up | 4 & 6 | |