Memory Set Switch
WARNING: This page is about a different car, the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, and 2001 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
Remove memory set switch. See MEMORY SET SWITCH in REMOVAL & INSTALLATION. Measure resistance between indicated switch terminals with switch in appropriate position. See MEMORY SET SWITCH TEST table. See Fig 1. If resistance is more than 5 ohms between any test terminals, replace switch.
To test memory set switch LED, connect positive DVOM lead to memory set switch terminal No. 8. Connect negative lead to memory set switch terminal No. 9. Resistance should be more than .3 ohm. Reverse leads. Resistance should be more than 10 k/ohms. If resistances are not as indicated, replace switch. See MEMORY SET SWITCH in REMOVAL & INSTALLATION.
MEMORY SET SWITCH TEST
| Switch Position | Measure Resistance Between Terminals No. |
|---|---|
| 1 | 4 & 6 |
| 2 | 3 & 6 |
| Set | 1 & 6 |