LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2002 >> LS 3.9 A >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul >> Disassembly & Assembly Of Subassemblies >> Reverse Servo Assembly >> Disassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reverse Servo Assembly: Disassembly

  1. Remove the control valve spring retainer.
    Fig 1: Removing Control Valve Spring Retainer
    G01673975Courtesy of FORD MOTOR CO.
  2. Remove the reverse servo spring and check valve.
    Fig 2: Removing Reverse Servo Spring & Check Valve
    G01673976Courtesy of FORD MOTOR CO.
    3. WARNING: The upper and lower servo covers are under spring tension. Use care when separating the two halves. Failure to follow these instructions may result in personal injury.
    NOTE: Tabs on servo plate mate with slots on cover every 120 degrees.
  3. Remove the reverse servo plate by turning in either direction to release.
    • Align arrow on servo plate with any slot on cover.
      • Fig 3: Aligning Arrow On Servo Plate With Any Slot On Cover
      G01673977Courtesy of FORD MOTOR CO.
  4. Remove the reverse servo spring.
    Fig 4: Removing Reverse Servo Spring
    G01673978Courtesy of FORD MOTOR CO.
  5. Remove the reverse servo piston and seal assembly.
    • Inspect the seal for damage, install new reverse servo piston if necessary.
      • Fig 5: Removing Reverse Servo Piston & Seal Assembly
      G01673979Courtesy of FORD MOTOR CO.
  6. Remove and discard the reverse servo piston seal.
    Fig 6: Removing Reverse Servo Piston Seal
    G01673980Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals