Climate Controlled Seat Module: Removal
NOTE:
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
When installing a new dual climate control seat module (DCSM), it is necessary to carry out programmable module installation (PMI). For additional information, refer to MODULE CONFIGURATION
.
NOTE:
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Before removing the DCSM, carry out the appropriate steps in the PMI procedure. For additional information, refer to MODULE CONFIGURATION .
- Remove the front passenger seat. For additional information, refer to Seat - Front .
- Remove the DCSM from the cushion electrical bracket.
- Release the locking wedges and disconnect the 3 DCSM electrical connectors.
- Remove the 2 rivets and DCSM.