LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2007 >> Navigator 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle/Transmission >> Disassembly And Assembly Of Subassemblies >> Pump Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pump Assembly: Assembly

    NOTE: Prior to installation, lightly lubricate the pump gears with clean automatic transmission fluid.
  1. Install the pump gears, with the dot facing the control body assembly.
    2. Fig 1: Locating Pump Gear Dots
    GF0022681Courtesy of FORD MOTOR CO.
  2. Install a new pump body outer seal.
    3. Fig 2: Locating Pump Body Outer Seal
    GF0022679Courtesy of FORD MOTOR CO.
  3. Assemble the control body and stator assembly onto the pump body and install the bolts.
    • Tighten to 15 Nm (11 lb-ft).
    4. Fig 3: Locating Plate Assembly To Pump Body Bolts
    GF0022678Courtesy of FORD MOTOR CO.
    CAUTION: Make sure the seal ends are correctly positioned together and not separated.
  4. Install the 2 coast clutch Teflon® seals. Make sure the seals are fully seated in the stator support seal grooves and the seal ends are oriented 180 degrees apart.
    5. Fig 4: Front Pump Stator Support Seals
    GF0022677Courtesy of FORD MOTOR CO.
  5. Install the pump outer diameter front pump O-ring seal.
    6. Fig 5: Locating Front Pump O-Ring Seal
    GF0022676Courtesy of FORD MOTOR CO.
  6. Using the special tool, install the front pump seal.
    7. Fig 6: Identifying Special Tool
    GF0022682Courtesy of FORD MOTOR CO.
    NOTE: Lightly lubricate the thrust washer with petroleum jelly to hold it in place during assembly.
  7. Install the pump thrust washer.
    8. Fig 7: Locating Front Pump Washer
    GF0022675Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals