Removal and Installation

NOTE: The speed control sensor is also known as the forward looking sensor.

NOTE: If a new C-CM is installed, the C-CM requires a parameter reset to allow the C-CM and the speed control sensor to recognize each other. Failure to carry out the parameter reset to the C-CM may result in an inoperative adaptive cruise control system condition.

Remove the rear seat. For additional information, refer to SEATING .
Remove the C-CM push-pin with a suitable pry-tool.
- Disconnect the electrical connector.
Remove the 2 C-CM nuts and the C-CM .
- To install, tighten to 11 Nm (97 lb-in).
If replacing the bracket, remove the 2 C-CM bracket nuts and the bracket.
- To install, tighten to 11 Nm (97 lb-in).
To install, reverse the removal procedure.
- Follow the scan tool on-screen instructions to carry-out the C-CM calibration procedure.
  - Follow the operating instructions shown on the Integrated Diagnostic System (IDS).
  - After completion of the test, verify that the test completed successfully.
  - Follow the prompts to drive the vehicle after successful completion of the test.