Removal and Installation

All vehicles 

1. NOTE: Module configuration is required when a new audio Rear Control Unit (RCU) module is being installed.

   Upload the audio RCU  module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .

   Navigator 

2. Remove the floor console cupholder.
3. Remove the 2 screws securing the rear trim panel to the floor console.

   Expedition 

4. Remove the 2 screws under the armrest cover.
   Fig 1: Locating Armrest Cover Screws

   Courtesy of FORD MOTOR CO.

   All vehicles 

5. Remove the bolt and the center console rear trim panel.
   • Disengage the pin-type retainers.
   • Disconnect the audio RCU  module electrical connector.
6. Remove the RCU  module.
   • Remove the 4 screws.
7. To install, reverse the removal procedure.

• Download the configuration information to the audio RCU  module. For additional information, refer to PMI  in MODULE CONFIGURATION .