LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lincoln >> 2010 >> MKT Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1680 (Information System And Entertainment System) >> Removal And Installation >> Accessory Protocol Interface Module (APIM) >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2010 Lincoln MKX and 2010 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: It is necessary to record the current Accessory Protocol Interface Module (APIM) software and hardware level when a new APIM  is being installed to make sure that the new component is the same version as the component being replaced.
  1. Retrieve and record the current APIM  software and hardware level. For additional information, refer to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) SOFTWARE LEVEL CHECK  .
  2. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
  3. Disconnect the Universal Serial Bus (USB) cable and the electrical connector.
  4. Remove the 4 screws and the APIM  .
  5. To install, reverse the removal procedure.
    • If a new APIM  is being installed, program the APIM  to the correct software level. For additional information, refer to MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals